Foxconn 915A03-P-8EKRS Mainboard Based on Intel 915P
|
This mainboard is absolutely identical to Foxconn
915A01-P-8EKRS, which we already reviewed, except for a different
memory type. That's why this review is mostly nominal, as it practically
copies the previous review.
The PCB layout is standard, one should note an inconvenient placement of the audio-in jack and the density of memory slots. Access to jumpers is not hampered, when the mainboard is in a case, their brief descriptions are provided on the PCB. The 3-phase switching voltage regulator of the processor incorporates four 1800 uF capacitors and ten 560 uF capacitors. The PCB also contains voltage regulators for the PCI-E x16 bus (2x1000 uF) and for memory (4x1000 uF).
The PCB lacks the following elements, which seats are provided by the layout: COM port and WOM, SATA RAID and its connectors. Mainboard dimensions – 305x245 mm (full-sized ATX, ten-screw mount, all mainboard edges are firmly fixed). The ITE IT8712F-A chip is used to monitor:
- CPU voltage, +2.6, +3.3, +5, +/-12 V and VBAT
- RPM of 2 fans
- CPU temperature (by the embedded CPU sensor)
- Board temperature (by the on-board sensor)
Onboard ports, sockets, and connectors
- CPU socket (Socket 775)
- 4 x DDR SDRAM DIMM (colored, grouped in pairs)
- 1 x PCI-E x16 (with a latch)
- 3 x PCI-E x1
- 3 x PCI (32bit, 33MHz)
- Power connectors: standard EPS12V (24 pins) and 4-pin connector for 12 V
- 1 x FDD
- 1 x IDE (Parallel ATA) – in the chipset
- 4 x SATA (Serial ATA) – all in the chipset
- 2 connectors for brackets with additional USB (2.0) ports
- Connector for the bracket with an additional FireWire port
- 1 x CD/DVD audio connector
- 1 x standard IrDA connector
- Connector for a chassis intrusion sensor
- WOL connector (Wake-On-LAN)
- TPM connector (Trusted Platform Module)
- Headers for additional Audio-Outs and S/PDIF
- 2 fan headers (with rpm control).
Back panel (left to right, blockwise)
- PS/2 mouse and keyboard
- LPT, 1 x COM-port
- 2 x USB and 1 x FireWire
- 2 x USB and 1 x RJ-45 (Gigabit Ethernet)
- 6 x Audio (Mic-In, Line-In, Front, Center/Sub, Rear, Side)
Package Contents
- Standard design box
- Documentation (in English):
- User's guide
- SATA RAID setup guide
- Cables:
- ATA66/100/133
- 1 x FDD
- 1 x SerialATA (with a SATA power converter)
- Rear I/O shield
- Rear panel bracket with 2 x USB
- Rear panel bracket with Coaxial S/PDIF-Out
- Floppy with SATA RAID drivers
- CD with software:
- mainboard drivers
- Adobe Acrobat Reader
- Norton Internet Security 2004
- Foxconn SuperUtilities
- DirectX 9.0b
We can note the SATA power converter (useful accessory for the owners of power units without Serial ATA power connectors) and Norton Internet Security 2004 – fairly good personal firewall (the latest version). Foxconn SuperUtilites is a set of utilities, which functionality can be easily guessed from their titles: SuperBoot, SuperBIOS-Protect, SuperStep (overclocking), SuperLogo, SuperUpdate.
Integrated Controllers
- Avance Logic ALC880 HD Audio Codec supporting 7.1 surround sound audio, with front line-in/out and S/PDIF jacks
- Network controller based on the Realtek RTL8110S-32 chip supporting 10Base-T/100Base-TX/1000Base-T
- FireWire based on the VIA VT6307 chip supporting two FireWire ports
It's interesting to see the FireWire support in the mainboard of the mATX format, which is traditionally associated with inexpensive budget solutions.
The integrated audio quality was tested in 16bit, 44 kHz using the RightMark
Audio Analyzer 5.1 test application and the Terratec
DMX 6fire sound card:
FR passband
ripple (from 40 Hz to 15 kHz), dB: |
+0.14, -0.17
|
Very good
|
Noise level,
dB (A): |
-86.6
|
Good
|
Dynamic range,
dB (A): |
86.4
|
Good
|
THD, %: |
0.0035
|
Very good
|
Intermodulation
distortions, %: |
0.015
|
Very good
|
Channel crosstalk,
dB: |
-86.3
|
Excellent
|
General performance: Very good (details).
Settings
Jumpers and switches |
Clear CMOS jumper |
|
Flash recovery jumper (to block Boot Block BIOS flashing) |
In Award BIOS v6.00PG | Memory timings | + | CAS Latency, RAS to CAS Delay, RAS Precharge, Precharge Delay |
Memory frequency selection | + |
Auto, DDR333, DDR400, DDR533 |
AGP bus setup | + | |
PCI bus setup |
+ |
|
PCI bus setup | - | |
PCI frequency divider setup |
- | |
PCI IRQ manual assignment | + | |
FSB frequency setup | + |
100-350 MHz at 1 MHz steps |
CPU multiplier | + |
x8–x50 |
CPU core voltage control | + |
-0.0375 - +0.1 V at 0.0125 V steps |
Memory voltage control |
- | |
Chipset voltage control |
- | |
PCI-E bus voltage control |
- | |
We used BIOS dated 05.06.2004, the latest available BIOS version at the time of our tests.
Preliminary test results
|
Foxconn 915A03-P-8EKRS |
MSI 915P Neo2 Platinum |
Return to Castle Wolfenstein, 800x600x32 |
232 |
232 |
Adobe Photoshop 7.0, script execution |
00:08:21 |
00:08:14 |
DivX 5.1 Pro encoding |
00:07:20 |
00:07:15 |
7-zip archiving |
00:07:23 |
00:07:31 |
References
Write a comment below. No registration needed!
|
|
|
|
|